Your slab is a warehouse floor. Your members train on it like athletes. We fit short-pile gym turf over shock-absorbing underlayment so sled pushes, sprints and drop sets land on a surface built for them - installed by a crew whose shop is fifteen minutes from your door.
Based in Livermore
2133 Research Dr Unit 16
Installing since 2005
Owner-run, Bay Area only
Licence 1059264
C-61/D12 synthetic products
Turf is the trade
Not a flooring sideline
Most of Livermore's training space started life as light-industrial shell - Research Drive, Kitty Hawk, Airway Boulevard. Those slabs were poured for pallet racking, not for athletes.
A tilt-up warehouse slab is superb at holding weight and terrible at absorbing impact. Turf alone does not change that; the shock-absorbing underlayment under it does, and that is the layer people skip.
Triple-digit valley afternoons and cool nights swing slab temperature hard in a unit without air conditioning. Adhesive choice and seam layout have to allow for that movement, or the seams telegraph within a season.
A sled lane loads the same fibres in the same direction thousands of times. We run the pile direction along the lane and place seams outside the traffic path so the lane wears evenly instead of opening up.
Most Research Drive and Airway units are leased. Turf bonded over the slab is a tenant improvement that lifts at end of term - which is the version building owners actually sign off on.
Prepared concrete, a shock-absorbing pad, then short-pile training turf seamed tight. Three layers, and the middle one is the one your knees notice.
One trade, four jobs - matched to how the space actually gets used.
Marked turf lanes for sprints, shuttles and ladder work, with distance markings inlaid into the layout rather than taped on top of it where they wear off.
Turf over a heavier shock pad in the areas that take dumbbells, sleds and loaded carries, so the floor survives the drop and the slab underneath it does too.
Open turf areas for classes and circuits, laid so the whole floor reads as one surface with no trip edges between zones or where it meets rubber flooring.
Livermore garage conversions get the same short-pile turf and shock pad as the commercial jobs, trimmed to the roll-up door and finished properly at the threshold.
Real installs from the O'Neill's project galleries - training surfaces, lane markings and open turf floors.
Since 2005
Installing turf and hardscape across the Bay Area
Livermore
Office, yard and crew - not a franchise dispatch
1059264
California contractors licence (C-61/D12, C-27, C-8)
5 counties
Alameda, Contra Costa, San Francisco, Santa Clara, San Mateo
Sprint lanes, sport-specific zones and an inlaid logo are cut into the turf, not painted onto it. That means the layout has to be right on paper first, so we walk it with you and mark it out on the slab.
Short, because we are local - a site visit is a drive across town rather than a scheduled trip.
We walk the unit, measure the slab, check it for moisture and flatness, and talk through how the space gets used before anyone quotes anything.
Pile height, pad thickness, lane positions, colours and any inlaid logo get decided together and drawn up, so you approve the floor before it exists.
The slab is ground and profiled, the shock pad goes down, then the turf is rolled, cut, seamed and bonded. Most single-room gyms run two to three days.
We cut in the thresholds, clean up and show you how to look after it. Grooming a turf floor is a broom job, not a service contract.
We are on Research Drive, the same side of town as most of the gyms we fit. Call and you will speak to the people who will be standing on your slab.
Pavers and Turf by O'Neill's
Pavers and Turf by O'Neill's, 2133 Research Dr Unit 16, Livermore, CA 94550. Phone (925) 443-7888. Email [email protected]. Open Monday to Friday 8am-5pm; Saturday and Sunday closed. California contractors licence 1059264 (C-61/D12 synthetic products, C-27 landscaping, C-8 concrete).
Almost always yes - a sound concrete slab is the ideal base. What matters is preparation: the slab is ground and profiled so the adhesive bonds, and we moisture-test first, because a slab poured without a vapour barrier can push moisture up into the adhesive later.
Turf on its own is a surface, not a cushion. The give comes from the shock-absorbing underlayment beneath it, which is why we specify the pad for what you actually do on the floor rather than fitting one thickness everywhere.
Sleds are exactly what this turf is built for. We run the pile direction along the sled lane and keep seams out of the traffic path, which is the difference between a lane that wears evenly and one that opens up.
Yes, and that is normally how we specify a leased space. Turf bonded over the slab is a tenant improvement that lifts at end of term without taking the concrete with it. Tell us it is leased and we will spec it that way from the start.
Most single-room Livermore gyms run two to three days from first grind to training on it. Larger multi-zone facilities take longer, and we can phase a floor so half the room stays open if closing entirely is not an option.
Yes. Lane lines, distance markings, sport-specific zones and an inlaid logo are cut into the turf as coloured inserts rather than painted on, so they do not wear off under sled and shoe traffic.
A Livermore gym rarely does one thing. The turf gets zoned so sprint work, strength and class space each get the pad and layout they need, without the floor breaking into patches that do not meet properly.
Call (925) 443-7888, or read the full indoor gym turf installation service at paversandturf.com/indoor-gym-turf-installation/ - then we will come and look at your slab.